Now, if you want to measure the audio signal output and control output of an audio object of the added device. You need to configure Streaming functionality in a signal flow design.
- Go to the Device Designer window and select the virtual core of the device.
- Go to the virtual core properties and select the Streaming checkbox to enable streaming functionality.
- Enter the desired number of Level Meters that need to be added to the signal flow to monitor control-out connections or audio.
- Click Save to save the changes and click on Send Device Config.
- Double-click on the Xaf Instance to open the Signal Flow Designer window.
- On the Signal Flow Designer window, right-click on the audio connections, and select Level Meter > RMS. This action adds Level Meters in the signal flow design.
- Open Preset Controllers, click on Add Slot, and set Group 1 as LFHighOnly.
- Similarly, add another slot and set Group 1 as AllSpeakers.
- Click on Send to Device. When the preset data has been successfully sent, a completion message is displayed to indicate that the transmission was successful.
If an error occurs, an error message is displayed. - Click on Load Slot. The GTT sends a slot load request to the device and waits for a response.
If the device is successfully loaded into the slot, a success message is displayed on the screen. Now you can perform tuning. - Double-click on the audio object to open the native panel. On the native panel, change the value using the slider and check the level meter value.
- Similarly, open the IVP RTA window, go to the native panel, change the value using the slider, and check the signal graph.
